Transcell Technology TC-2005 Series Setup & Operation Manual page 8

S tep 4. If applicable, install the remote scale.
1. Connect the remote scale to the TC-2005's remote scale port using the provided remote
scale cable. Consult Appendix D for proper cabling.
2. Configure the remote scale's parameters in the User Menu as detailed in Chapter 5.
3. Calibrate the remote scale as detailed in Chapter 6.
4. Enable the remote scale in the User Menu as detailed in Chapter 5.
S tep 5. Switch the scale ON to begin use.
1. Locate the power switch on the rear panel and switch to the ON (1) position.
2. Push the ON/OFF key on the scale's front panel.
8