Vent Valve; Vent Blower; Door Latch Assembly; Detergent / Rinse Aid Dispenser - Electrolux GLDB957JB series Service Manual

VENT VALVE

1. Disconnect dishwasher from electrical supply.
2. Remove outer door panel.
3. Remove control panel.
4. Remove door vent assembly.
5. Slide vent valve upward to remove from actuator
arm.

VENT BLOWER

1. Remove door vent assembly.
2. Remove two screws securing top vent piece.
3. Remove four screws securing lower vent to
blower motor.

DOOR LATCH ASSEMBLY

1. Disconnect dishwasher from electrical supply.
2. Remove outer door panel.
3. The door latch is held to the inner door panel
with two screws and two locator pins. Remove
screws and pull to remove.
4. To remove door switches, push plastic bracket
open and rotate bottom of switch up.

DETERGENT / RINSE AID DISPENSER

1. Disconnect dishwasher from electrical supply.
2. Remove outer door panel.
3. Disconnect wiring connections.
4. Remove six Phillips screws and carefully push
dispenser into tub.

INNER DOOR PANEL

1. To replace inner door panel, remove control
panel, door vent, dispenser and latch.
2. Remove two bolts (T-25 TORX
hinge and lift off.

DOOR SEAL

1. To remove seal, lift one end and pull entire seal
out.
2. To replace or reinstall seal, center white mark at
top of seal recess and press seal in place, going
left and then right from top center. Do not stretch
seal while installing.

UPPER RACK

1. To remove rack, unsnap and remove retainers at
end of metal track. Once retainers are removed,
pull rack straight out.
Page 17
) from each
®