Table of Contents
Advertisement
Water inlet hose with safety valve
After connecting the double-walled water inlet hose, the safety valve is next to
the tap. Therefore the water inlet hose is only under pressure while the water is
running. If the water inlet hose starts to leak during this operation, the safety
valve cuts off the running water.
P P l l e e a a s s e e t t a a k k e e c c a a r r e e w w h h e e n n i i n n s s t t a a l l l l i i n n g g t t h h e e w w a a t t e e r r i i n n l l e e t t h h o o s s e e : :
- The electrical cable for the safety valve is in the double-walled water inlet
hose. Do not immerse the water inlet hose or the safety valve in water.
- If water inlet hose or the safety valve is damaged, remove the mains plug
immediately.
- A water inlet hose with safety valve must only be replaced by a specialist or
by the Service Force Centre.
- Place the water inlet hose in such a way that it is never higher than the
bottom edge of the safety valve.
Installation
W W a a r r n n i i n n g g ! !
D D a a n n g g e e r r o o u u s s v v o o l l t t a a g g e e
39
Advertisement
Table of Contents
