Vent Housing And Vent Grate; Dispenser; Lower Spray Arm; Upper Rack - Electrolux FMB330RGB0 Service Manual

Vent Housing and Vent Grate

1. Disconnect power to the dishwasher.
2. Remove console from inner door panel.
3. Remove the four screws holding vent housing and
vent grate located inside together.
4. On reassembly, make sure gasket is in place in vent
housing.

Dispenser

1. Disconnect power to the dishwasher.
2. Remove outer door panel.
3. Remove six screws holding dispenser into door
panel. Remove mounting reinforcements from
dispenser.
4. Remove two wires from dispenser wax motor.
Terminals have locks press down on lock to remove
terminal.

Lower Spray Arm

1. Turn the lock clockwise to release arm.
2. When reinstalling arm turn lock counter clockwise
until lock clicks.
The lower spray arm has a lock holding it
to the spray arm support
Vent Housing
Dispenser

Upper Rack

1. Slide rack rail forward the end cap on the rail has a
lock.
2. Push lock over and slide end cap off rail.
3. Slide rack from rails.

Center Spray Arm

1. Turn the lock clockwise looking down from top of
rack to release arm.
2. When reinstalling arm turn lock counter clockwise
looking down from top of rack until lock clicks.
There is a gasket inside the spray arm and locking
in place will be tight make sure spray arm is fully
locked to delivery tube.
The center spray arm has a lock holding it to the
delivery tube mounted under the upper rack

Door Seal

1. To remove the door seal, pull free from the channel
around the tub.
2. Locate the inside of new seal. Go to the end of the
seal one side will be shaved off. This is the inside.
3. Find center
of seal. Push
center of seal into
channel at strike
first to hold in
place.
4. Go to bottom and
adjust seal so end
is on bottom of
tub and push into
channel.
12
End cap lock