Diagonal Cutting - MK Diamond Products MK-660 SERIES Owner's Manual & Operating Instructions

SETUP, ADJUSTMENT and OPERATION

2. Diagonal Cutting:

NOTE: To cut diagonal, the Dual 45º Flat Angle Guide (MK Diamond Part No. 134557-MK) should be used.
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was designed.
Turn counter-
clockwise to loosen
(A)
Remove the Adjustable Cutting
Guide
NOTE: If Cutting the tile in two equal halves, align the tile in the V-notch of the Movable Cutting Table
Ruler/Stop.
(D)
Position the tile against the
Dual 45º Flat Angle Guide and
the Ruler/Stop
Hold Work
in Position
Direction
of Cut
(G)
Perform the cut
MK-660
Adjustable
Turn counter-
Cutting Guide
clockwise to loosen
Ruler/Stop
Place the Dual 45º Flat Angle
Guide on the Ruler/Stop
45º Flat On
Angle Guide Position
ON/OFF
Ruler/Stop
Switch
Turn the motor ON
ON/OFF
Switch
Turn the motor OFF when work
Revision 07/04, Effective Date July 6, 2004
Align Guide
to Ruler/Stop
Ruler/Stop
(B)
(E)
Off
Position
(H)
is complete
Turn Clockwise
to tighten
(C)
Position the Dual 45º Flat
Angle Guide and tighten the
retaining thumbscrew
Cooling Flow
Points
(F)
Verify cooling flow on both sides
of the blade (See Maintenance
Section to adjust flow)
Page 20