MK-370EXP
ADJUSTMENT & OPERATION
DIAGONAL CUTTING
NOTE: To cut diagonal, the Dual 45º Flat Angle Guide (MK Diamond Part No. 134557-MK) should be used.
CAUTION
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which
it was designed.
(A)
(B)
(C)
Remove the Adjustable
Place the Dual 45º Flat
Position the Dual 45º Flat
Cutting Guide
Angle Guide on the Ruler/
Angle Guide and tighten
Stop
the retaining knob
NOTE: If Cutting the tile in two equal halves, align the tile in the V-notch of the Movable Cutting Table
Ruler/Stop.
Ruler/Stop
(D)
(E)
(F)
Position the tile against the
Turn the motor ON
Verify cooling flow on both
Dual 45º Flat Angle Guide
sides of the blade
and the Ruler/Stop
(G)
(H)
Perform the cut
Turn the motor OFF when
work is complete
24