Diagonal Cutting - MK Diamond Products MK-100 SERIES Owner's Manual & Operating Instructions

SETUP, ADJUSTMENT and OPERATION

2. Diagonal Cutting:

NOTE: To cut diagonal, the Dual 45º Flat Angle Guide (MK Diamond Part No. 134557-MK) should be used.
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was designed.
Adjustable
Turn counter-
Cutting Guide
clockwise to loosen
Ruler/Stop
(A)
Remove the Adjustable Cutting
Guide
NOTE: If Cutting the tile in two equal halves, align the tile in the V-notch of the Movable Cutting Table
Ruler/Stop.
45º Flat
Angle Guide
Ruler/Stop
(D)
Position the tile against the Dual
45º Flat Angle Guide and the
Ruler/Stop
Hold Work
in Position
Direction
of Cut
(G)
Perform the cut
MK-100
Turn counter-
clockwise to loosen
(B)
Place the Dual 45º Flat Angle
Guide on the Ruler/Stop
ON/OFF
Switch
(E)
Turn the motor ON
ON/OFF
Switch
Turn the motor OFF when
work is complete
Revision 06/05, Effective Date June 07, 2005
Align Guide
to Ruler/Stop
Ruler/Stop
On
Position
Off
Position
(H)
Turn Clockwise
to tighten
(C)
Position the Dual 45º Flat Angle
Guide and tighten the
retaining thumbscrew
Cooling Flow
Points
(F)
Verify proper cooling flow on
both sides of the blade (See
Maintenance Section to
increase/decrease flow)
Page 19