Adjustment And Operation - MK Diamond Products MK-101 Tracker Owner's Manual

SETUP, ADJUSTMENT and OPERATION

ADJUSTMENT and OPERATION:

1. Cutting Straight Edges:
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was
designed.
Turn Counter-
clockwise to loosen
(A)
Loosen the Adjustable Cutting
Guide retaining thumbscrew
Adjustable
Cutting Guide
Ruler/Stop
(D)
Place the tile against the
Ruler/Stop and Cutting Guide
Hold Work
in Position
Direction
of Cut
(G)
Perform the cut
MK-101 TRACKER
(B)
Position the Adjustable Cutting
Guide to desired cut length
indicated inside the diamond
ON/OFF
Switch
(E)
Turn the motor ON
ON/OFF
Switch
Turn the motor OFF when
work is complete
Revision 06/05, Effective Date June 07, 2005
Desired Cut length
indicated here
On
Position
Off
Position
(H)
Turn Clockwise
to tighten
(C)
Tighten the retaining
thumbscrew
Cooling Flow
Points
(F)
Verify proper cooling flow on
both sides of the blade (See
Maintenance Section to
increase/decrease flow)
Page 18