Adjustment And Operation - MK Diamond Products BX-3 Owner's Manual, Parts List And Operating Instructions

BX-3

ADJUSTMENT AND OPERATION:

1. Cutting Setup:
Ruler/Stop Set Edge of Cutting
Guide to Desired Cut
Length on Ruler/Stop
Ruler Markings
(A)
Set Adjustable Cutting Guide
DO NOT FORCE the blade to cut, it will do the job better and safer at rate for which it was
designed.
2. Step Cuts:
A Step Cut is performed when a series of small cuts of increasing depth are used to complete a single cut.
Step Cuts are used for large objects or for hard objects such as Firebrick and Pavers.
NOTE: 1. Step Cutting is the preferred cutting method for all cuts.
2. When cutting hard material Step Cutting should always be used.
3. Step Cutting will extend the life of the Diamond Blade.
Depress Trigger to
Start (Lock if Desired)
(A)
Step Cut Setup
Repeat "Push"
and "Pull" Strokes
Until Cut Complete
(D)
Repeat Steps B and C
Until Cut Complete
Adjustable
Cutting Guide
Position Masonry Piece
Hold Work
in Position Push Direction
Step Cut "Push" Stroke
Raise Cutting
Head
Cutting Complete
Set against Adjustable
Cutting Guide and
Ruler/Stop
Ruler/Stop
(B)
Lower Cutting
Head 1/4 -1/2
Inch During
Push Stroke
(B)
Release Trigger Switch
Allow Blade to
Stop Before
Removing Work
(E)
17
ADJUSTMENT
Lower Cutting
Head Additional
1/4 -1/2 Inch During
Pull Stroke
Pull Direction
(C)
Step Cut "Pull" Stroke