Preparation - Toto WASHLET S350e Instruction Manual

Preparation

Using the Washlet for the First Time
1. Insert the battery.
Remove the remote control
1
from the hanger.
Hanger
2 Open the battery cover and
insert two AA batteries.
AA batteries x2
Close
Open
Battery cover
Mount the remote control in
3
the hanger.
■
About the batteries
●
Use dry cell, alkaline batteries. Follow the
instructions below to prevent the batteries from
rupturing or leaking fluid.

When replacing the batteries, use new batteries of
the same brand.

If you will not be using the remote control for a long
time, remove the batteries.

Do not use rechargeable batteries.
16
When the remote control is locked to
prevent theft
Remove the screw from the
1
remote control fixture.
(Side view)
Remote control
Wall
Hanger
Screw
Loosen
Phillips screwdriver
2 Remove the remote control
from the hanger.
●
To return

Tighten the screw. (Overtightening may
cause damage to parts such as the hanger.)
2. Turn on the power.
[USA]
1
Insert the power plug.

The wand extends and then retracts.
[Asia, Oceania]
Switch the breaker on the
distribution board to ON.

The wand extends and then retracts.
Check that the POWER LED
2
on the main display is lit up.

If the LED is not lit up, pressing [POWER
ON/OFF] will light it up.

If the POWER lamp flickers, the main unit is
not installed properly. Mount the main unit
again. (Page 34)
3. Open the water supply valve.
Fully open the water supply
1
valve.
17