Operational Precautions - Toto WASHLET S350e Instruction Manual

Safety Precautions
Grounding Instructions
This product should be grounded. In the event of an electrical short circuit, grounding reduces
the risk of electric shock by providing an escape wire for the electrical current.
The plug must be plugged into an outlet that is properly installed and grounded.
DANGER - Improper use of the grounding plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to
either flat-head terminal.
Check with a qualified electrician or serviceman if the grounding wire instructions are not
completely understood, or if in doubt as to whether the product is properly grounded.
This product is factory equipped with a specific electric cord and plug to permit connection to
a proper electric circuit. Make sure that the product is connected to an outlet having the same
configuration as the plug.
No adapter should be used with this product. Do not modify the plug provided - if it will not fit in
the outlet, have the proper outlet installed by a qualified electrician.
If the product must be reconnected for use on a different type of electric circuit, the reconnection
should be made by qualified service personnel.
If it is necessary to use an extension cord, use only a three wire extension cord that has a three
blade grounding plug, and a three-slot receptacle outlet that will accept the plug on the product.
Replace or repair a damaged cord.
Save these instructions.
10
(Continued)
Grounding pin

Operational Precautions

■
For prevention of malfunctions
●
Do not block the body sensor or the remote control
transmitter or receiver.
<About the Body Sensors>
Two types of body sensor are used.
●
Body sensor A detects changes in heat.
 
Detection may be difficult when the room
temperature exceeds 30°C, such as in the
summertime.
 
When sunlight is directly on the sensor area or a
heater is used in the bathroom, the sensor may
detect incorrectly due to the heat, resulting in the
automatic operation of functions such as auto lid
opening and closing.
 
When the bathroom door is open, the sensor may
detect people who pass to the front or side of the
toilet.
●
Body sensor B detects when someone stands in
front of the toilet bowl.
 
Body sensor B emits an infrared beam as shown
in the figure. When someone moves into the line of
this infrared beam, the sensor detects the person.
* Detection by the sensor may be difficult when the
toilet is used by someone small, such as a child.
Body sensor A Body sensor B
S350e TCF4732A
S300e TCF4731A
<About the seat switch>
●
When you sit on the toilet seat, the seat switch
turns ON, enabling you to use various features.
(A click sound is heard when the seat switch is
ACTIVATED.)
Switch
ON
Gap
The toilet seat lowers.
Seat switch
(Built-in)
●
The seat switch will not turn on unless you sit on
the seat properly.
Note
●
When a child uses the Washlet, the seat
switch may not be ACTIVATED their light
body weight.
●
Since the toilet seat is designed to move up
and down, a clearance is provided between
the toilet seat cushion and the toilet bowl.
■
For prevention of damage
●
Wipe plastic areas such as the main unit and remote
control with a soft, wet cloth.
●
Do not lean against the toilet lid.
■
Problem Prevention
[USA]
●
Disconnect the power plug if there is a risk of lightning.
[Asia, Oceania]
●
Switch the breaker on the distribution board to OFF if
there is a risk of lightning.
●
A toilet seat cover or a toilet lid cover cannot be used.
(The body sensor or seat switch may not function properly.)
Cover
●
Do not urinate on the main unit, toilet seat or wand.
(Doing so may cause pink or brown stains or a malfunction.)
●
Do not apply strong forces to the control panel of the
remote control.
●
When using a toilet bowl cleaner to clean the toilet,
wash it off within 3 minutes and leave the toilet seat
and toilet lid open.
 
Wipe off any cleaner that remains on the toilet bowl.
(If vapor from a toilet bowl cleaner enters the main unit,
it may cause to a malfunction.)
●
Do not expose to direct sunlight.
(Doing so may cause temperature changes resulting in
changes in color, irregular heated seat temperature, a
remote control malfunction, or a Washlet malfunction.)
●
Use radios, etc. away from the Washlet.
(The Washlet could cause interference with the radio signal.)
●
If you use a booster seat for infants or a soft highchair,
remove it after use.
(Keeping it installed may prevent some of the functions
from being used.)
●
Do not apply force to the remote control.
(May cause malfunctions.)
To prevent the hanger from being dropped, set it in the
remote control hanger when you are not using it.
Be careful not to expose it to water.
About rear cleansing, soft rear cleansing, front
cleansing and wide front cleansing
 
These functions wash away waste and dirt from a
localized area of your body.
 
Do not cleanse too much or for too long.
 
Doing so may wash away normal bacteria,
upsetting the balance of bacteria inside your body.
 
People who are receiving medical treatment or
therapy in this localized area should consult their
doctor before use.
11