Related Manuals for Hansol 520f
Summary of Contents for Hansol 520f
-
Page 1: Table Of Contents
*1¿ 97.3.29 10:25 AM ˘ ` 1 Contents U s e r Õ s G u i d e How to get the most enjoyment with monitor ¥ Features ¥ General Safety precautions ¥ Maintenance Installation ¥ Packing List ¥ Control description ¥... -
Page 2: How To Get The Most Enjoyment With Monitor
DDC compatible video Overloaded AC outlets and extension cords card and contact HANSOL Service Center. are dangerous. So are frayed power cords and broken plugs. They may result in a shock or fire hazard. -
Page 3: Maintenance
*1¿ 97.3.29 10:25 AM ˘ ` 4 Installation Packing List Do not use the sharp tool such as pin or pencil to avoid the scratch on the LCD surface. Do not use the solvent such as benzene to clean the monitor. It will damage to LCD surface. -
Page 4: Control Description
*1¿ 97.3.29 10:25 AM ˘ ` 6 Control description Connecting with external equipment Front View Cautions Be sure to turn off the power of your computer before connecting the Monitor. M (Menu) OSD KEY S (Select) POWER KEY LED INDICATOR Rear View Video input terminal A 15 pin D-sub connector is used as the input signal connector. -
Page 5: On Screen Display(Osd) Control Button
*1¿ 97.3.29 10:26 AM ˘ ` 8 On Screen Display (OSD) Control Button Exit Menu Press the MENU key to exit. The power LED is lit green. Auto exit POWER ON / OFF The OSD images are disappeared automatically after few seconds inactivity. POWER LED INDICATOR Auto save SELECT... -
Page 6: On Screen Display Setting
*1¿ 97.3.29 10:26 AM ˘ ` 10 On Screen Display Setting Preset Mode chart Timing Charts Auto Adjustment Automatically adjust the vertical position, Horizontal Geometry Support video timings this monitor shall be capable of display following video position, Horizontal size and Phase timing chart. -
Page 7: Microcontroller Features
*1¿ 97.3.29 10:26 AM ˘ ` 12 Microcontroller features Preset Mode Table The timing shown in the following table will be factory preset for display. The microcontroller automatically detects the video board installed in your system. When you turn on the monitor, the Micro controller first checks the display mode memory stored in the user setting area and the factory presetting Horizontal Pi x el 640... -
Page 8: Power Management
*1¿ 97.3.29 10:26 AM ˘ ` 14 Power management Specifications This monitor equipped with DPMS(Display Power Management Signaling) Type TFT Color function which automatically leads the monitor to the state of power saving Size 15.0Ó viewable, diagonal that consumes just a little power less than 5Watt, when the computer is left Dot Pitch 0.297 X 0.297(mm) unattended.