Page 3
Combo board PCB Semiconductor Aead Identification 11. Schematic Diagram Copyright 2003 by Hansol LCD Inc. All rights reserved. This manual may not, in whole or in part, be copied, photocopied, reproduced, translated, or converted to any electronic or machine readable form without prior written permission of Hansol Electronics Inc.
Precautions 1. Precautions Follow these safety, servicing and ESD precautions to prevent damage and to protect against potential hazards such as electrical shock. 1-1 Safety Precautions 1-1-1 Warnings 1. For continued safety, do not attempt to modify the circuit board. 2.
Page 5
Precautions c. Use a SSVM or VOM with 1000 ohms per-volt or higher sensitivity to measure the AC voltage drop across the resistor (see Figure 1-1). d. Connect the resistor to an exposed metal part having a return path to the chassis(metal cabinet, screw heads, knobs, shafts, escutcheon, etc.) and measure the AC voltage drop across the resistor.
Precautions 1-2 Servicing Precautions WARNING : An electrolytic capacitor installed with the wrong polarity might explode. Caution : Before servicing instruments covered by this service manual and its supplements, read and follow the Safety Precautions section of this manual. Note : If unforeseen circumstances create conflict between the following servicing preautions and any of the safety precautions, always follow the safety precautions.
Precautions 1-3 Electrostatically Sensitive Devices(ESD) Precautions Some semiconductor (solid state) devices can be easily damaged by static electricity. such components are commonly called Electrostatically Sensitive Devices(ESD). Examples of typical ESD devices are integrated circuits and some field-effect transistors. The following techniques will reduce the incidence of component damage caused by static electricity.
Precautions 2. Product Specifications 2-1 Specifications Model H950VI (B19BF) Type Amorphous Active Matrix Super TFT LCD (LTM 190E1 - L01) Screen Size 376.32(H) X 301.056(V) mm (19 inch diagonal) Maximum Resolution 1280 X 1024 @ 75Hz Pixel Range 0.294mm X 0.294mm LCD PANEL Display Colors 8 bit data =16.7 million colours...
Product Specifications 2-2 Pin Assignment The 15-pin D-sub connector(male) of the Analog signal cable Pin No. Assignment Pin No. Assignment Red Video 5V Input Green Video ST_DET Blue Video Ground Ground H.Sync Red Video Ground V.Sync Green Video Ground Blue Video Ground The 24 pin DVI-D cable Pin Connection Signal Signal...
Disassembly and Reassembly 3. Disassembly and Reassembly The section of the service manual describes the disassembly and reassembly procedure for H950VI. WARNING : This has to be disassembled and reassembled carefully because TFT-LCD Panel is weak for impact. This monitor contains electrostatically sensitive devices. Use caution when handling these components.
Page 12
Disassembly and Reassembly Fiqure Service Manual...
Page 13
Disassembly and Reassembly 3-2 Reassembly 3-2-1 Display part Reassembly Reassembly procedures are in the reverse order of Disassembly Procedures. Confirm that insulation plate puts into on the left of the TFT-LCD panel and main chassis. 3-2-2 Stand(Power Stand & Normal Stand) part Reassembly Reassembly procedures are in the reverse order of Disassembly Procedures.
Troubleshooting 4. Troubleshooting 4-1 Micom(WT61P4L44) We can check the micom operation correctly by press the soft power switch. When the chip does not operate in the normality, power indicating the LED is always extinguished. In the normality, if the screen appear 'No Signal' or 'No Cable', the LED is green amber. When the screen is displayed, the LED is green light.
Page 15
Troubleshooting 4-3-2 When screen is just black ! Check & Check Diagram Order point Replace Item LVDS Cable Check LVDS Cable is it ok? LVDS Cable INVERTER Check inverter lamp cable Is it OK? INVERTER Lamp Cable Lamp cable Does proper DC +5V COMBO &...
Exploded View & Parts List 5. Exploded View & Parts List 13-B 13-A 11-C 11-B 11-A 10-E 10-G 10-F 10-C 10-D 10-B 10-A 15-D 15-C 15-B 15-A Service Manual...
Page 17
Introduction Exploded View & Parts List Exploded View & Parts List PART NAME CODE NO. DESCrIPTION Q’TY PART NAME CODE NO. DESCrIPTION Q’TY...