Oce PP18C Operation Manual page 79

ADVANCED OPERATION GUIDE
Writing Data
Data can be written to a memory card until the card is full. When writing to
a memory card, a name is assigned to the file automatically. You can use
the procedure explained in the section Printing a List of Data Names
(Partitions) on page 2-56 to print a list of data names for confirmation.
NOTE:
First check that the memory card is properly formatted.
Otherwise, the >Write Data message to be explained below will not be
shown on the message display. If the memory card inserted in the
memory card slot is not formatted, >Format will automatically appear on
the message display. Format the memory card. See Formatting a Memory
Card on page 2-55.
1
Press [MENU].
2 Press or
Card > appears.
3 Press .
4 Press or
Data appears.
5 Press [OK] ([ENTER]). A question mark (?)
appears.
6 Press [OK] ([ENTER]). Processing appears, then Waiting.
7
Send the file from the computer to the printer.
As the printer receives data, the message display changes to
Processing, then when the end of the data is received, the message
display changes to Waiting.
8 Check that the message display has changed to Waiting, then press [GO].
This writes the file to the memory card and instructs the printer to
automatically print out a memory card write information page as shown
below.
The file is written onto the memory card given a destination name (also
referred to as a partition name) which the printer automatically assigns one
repeatedly until Memory
repeatedly until >Write
Using the Operator Panel
Memory Card
>Write Data
>Write Data ?
2-53
>