Oce PP18C Operation Manual page 66

Using the Operator Panel
2-40
6 Press [OK] ([ENTER]). A blinking question
mark (?) appears.
7 Select Regular or Dark using
8 Press [OK] ([ENTER]).
9
Press [MENU]. The display returns to Ready.
Changing the Default Font Size
You can change the size of the default font. If you selected a proportional
font, the character size can also be changed.
1
Press [MENU].
2
Press or
appears.
3
Press . Press
Select > appears.
4
Make sure that Internal is displayed and press
5
Press or
appears.
6
Press [OK] ([ENTER]). A blinking cursor (_)
appears.
7
Press or to increase or decrease the value at the blinking cursor. The
font size can be set between 4 and 999.75 points, in 0.25-point increments.
Use or to move the cursor right and left.
8 When the desired size is displayed, press [OK] ([ENTER]).
9 Press [MENU]. The display returns to Ready.
or
repeatedly until Font >
or until >Font
repeatedly until >>Size
>>Courier
? Regular
.
Font
>Font Select
Internal
.
>>Size
012.00 point(s)
>>Size
012.00 point(s)
ADVANCED OPERATION GUIDE
>
>