Oce PP18C Operation Manual page 56

Using the Operator Panel
Changing Serial Interface Parameters (FS-C5030N only)
2-30
8 Press or
• Nibble (high)
• Auto
• Normal
• High Speed
9 When the desired communication mode is displayed, press [OK]
([ENTER]).
10
Press [MENU] to exit the menu selection.
NOTE:
This section applies to the printer having the optional serial
interface board kit (IB-11) installed.
You can confirm or change the serial interface parameters including baud
rate, data bits, stop bits, parity, and protocol. These parameters must
match those of the computer's serial interface.
1
Press [MENU].
2
Press or
3 If the interface is other than serial, press
[OK] ([ENTER]). A blinking question mark
(?) appears.
4 Press or
appears.
5
Press [OK] ([ENTER]) again.
6 Press . One of the following serial parameters is indicated (Baud rate
for example).
to scroll through the following communication modes:
repeatedly until Interface > appears.
repeatedly until Serial
Interface
? Parallel
Interface
? Serial
ADVANCED OPERATION GUIDE