Lower Paper Separator Finger Removal; Upper Paper Eject Roller Removal - Epson EPL-N2700 Service Manual

EPSON EPL-N2700 / N2750

4.2.21.5 Lower Paper Separator Finger Removal

1. Remove the Lower Fusing Roller. (See Section 4.2.21.3.)
2. Remove the tension spring fixing the Lower Paper Separator Finger
to the Fuser Unit Frame.
Figure 4-51. Lower Paper Separator Finger Removal
Disassembly/Assembly

4.2.21.6 Upper Paper Eject Roller Removal

1. Remove the Fuser Unit. (See Section 4.2.21.1.)
2. Release the joint for the Fuser Unit Cover and the Fusing Roller
Heater Lamp Front Cover.
3. Remove one screw (3501) securing the Fusing Roller Heater Lamp
Front Cover to the Fuser Unit Frame Assembly, and remove the
Fusing Roller Heater Lamp Front Cover. (See Section 4.2.21.2.)
4. Remove one E-ring (9107) and one torsion spring securing the lever
to the rear part of the Fuser Unit and remove the lever.
5. Release the thermistor harness and paper eject sensor harness
from the cable clamps in the Fusing Roller Heater Lamp Rear
Cover.
6. Remove one screw (3501) securing the Fusing Roller Heater Lamp
Rear Cover to the Fuser Unit Frame Assembly and remove the
Fusing Roller Heater Lamp Rear Cover.
7. Remove two E-rings (9107) and two bushings fixing the Upper
Paper Eject Roller to the Fuser Unit Frame Assembly and remove
the Upper Paper Eject Roller.
Figure 4-52. Upper Paper Eject Roller Removal
Disassembly Procedure
Revision B
129