Epson EPL-N2700 Service Manual page 48

EPSON EPL-N2700 / N2750
<10-bin unit>
When "Multibin = Stacker" and "Outbin = Stacker" are selected:
o
The sequence of outbin destinations is Bin10 > Bin9 > ---> Bin 2
n
> Bin1
The printer searches some consecutive empty bins in the order
n
of Bin 2, Bin 3 - - -, and paper will be output to the empty bin
which found last in the search.
When "Multibin = Sorter" and "Outbin = Sorter" are selected:
o
The sequence of ejected paper destination is Bin10 > Bin 9 > - -
n
Bin1.
When "Multibin = MultiSort" and "Outbin = Sorter" are selected:
o
If requested copies is 9 or less, ejection starts at Bin 2. If
n
requested copies is 10 or more, ejection starts at Bin 1, and
when all pages are ejected, next ejection starts at Bin3 and then
in the following order; 4, 5, - - - 10, and 1.
<Items of restriction on the paper tray>
When the 5-bin or 10-bin is installed:
When the "Out Bin" is set to other than Face-down, "Outbin Select
Error" will occur if the printer is in any of the following conditions:
Paper size is any of the A5, B5, GLT, HLT, EXE, MON, C10, DL,
n
C5, or custom.
Paper type is other than "Plain".
n
"Paper Type" is set to "Transprnc" or "Label".
n
NOTE:To check the condition, see the paper source that was
selected by the user and also the one from which the paper
was fed.
Product Description
Quantity (Printing Menu)
The number of copies is specified by the job unit. It has a priority over
the number set for "Copies". Accordingly, if "Quantity" is set to "2" or
larger, the value set for "Copies" is not effective. This is set with EJL or
ESC/PAGE command. The setting value is not stored in memory. If on-
job data is too large to store, the printer shows the warning "Collate was
disabled" and prints one set only.
Duplex (Printing Menu)
Selects Single of Duplex printing.
<Items of restriction on the duplex printing>
When the printer is in any of the conditions below, "Can't Print Duplex"
is indicated and printing is disabled.
Paper size is any of the MON, C10, DL, C5, or custom.
n
Paper type is other than "Plain".
n
"Paper Type" is set to "Transprnc" or "Label".
n
NOTE:To check the condition, see the paper source that was
selected by the user and also the one from which the paper
was fed.
Panel Operation
Revision B
48