Msd-431-L Installation; Installing The Msd-431-L Into A Wall - AMX MST-431 Operation/Reference Manual

4.3” modero s series tabletop touch panel

Hide thumbs Also See for MST-431:

Table of Contents

Installation

MSD-431-L Installation

The MSD-431-L may be installed directly into a solid surface environment, using either solid surface screws

or the included locking tabs for different mounting options. Once installed, the MSD-431-L is contained

within a clear outer housing known as the back box (FIG. 9). This back box is removed when installing the

device into a wall or into a Rough-In Box.

FIG. 9

MSD-431-L Back Box

The MSD-431-L comes with a clear plastic backbox (designed to attach the panel to most standard wall

materials. This backbox has four locking tabs (two on top and two on bottom) to help lock the backbox to the

wall. These locking tabs are only extended AFTER the backbox is inserted into the wall. (FIG. 10 and

FIG. 11).

When installing the backbox, make sure that the assembly is in the correct position

and in the correct place. Once the locking tabs are extended and locked into place,

removing the backbox may be difficult without having access to the back of the wall

or causing damage to the wall.

For typical mounting surfaces, such as drywall, use the locking tabs as the primary

method for securing the back box to the surface. For thin walls or solid surfaces, use

mounting screws (not included).

MSD-431-L

FIG. 10

Side view of MSD-431-L

(front)

Locking tabs

Locking tab

Back box knockout

Back box

MST-431/MSD-431-L 4.3" Modero S Series® Touch Panels

Table of Contents

Msd-431-l