Wall Installation - AT&T 992 User Manual

0992_CIB_1ATT_FINAL_022105 2/22/04
Table/Desk Installation
continued from page 7
4 Connect the power cord.
CAUTION: Use only the power cord supplied
with this phone. If you need a replacement cord, call
1 800 222-3111
Fit the power cord behind the strain relief tab. Then plug the smaller
end of the power cord into the jack labeled POWER on the back
of the phone. Plug the power adapter into a standard electrical
outlet not controlled by a wall switch.
5 Check for dial tone.
Press L, then lift the handset or press S and listen for a
dial tone. Then press l and listen for a dial tone. If you do not
hear a dial tone, see IN CASE OF DIFFICULTY beginning on page 55.
6 Confirm Lines 1 and 2.
Press L and call one of your phone numbers. If you hear a busy
signal, you called Line 1. If you hear a ringing signal in the receiver,
then you called Line 2.
8
4:46 PM Page 8
.
Power
adapter
POWER
jack
Power
cord
Strain
relief tab

Wall Installation

1 Remove the desk wedge.
If the desk wedge is attached, remove it following the directions in
"Battery Installation" beginning on page 5. Store wedge in a safe
place in case you use this phone on a table or desk in the future.
2 Reverse the handset tab.
Hold down the switchhook, and slide the tab up and out of its slot.
Turn the tab so that the end with the "hook" is up, then insert the
tab back into its slot.
Figure 1 Figure 2
3 Connect the power cord to the phone.
Fit the power cord behind the strain relief tab. Then plug the smaller
end of the power cord into the jack labeled POWER on the back
of the phone.
POWER
jack
4 Connect the handset to the telephone.
Plug the coiled handset cord into the handset jack on the left side of
the phone. Plug the other end of the coiled cord into the handset,
then hang up.
Figure 3
Strain
relief tab
continued on page 10
9