AT&T 992 User Manual page 7

0992_CIB_1ATT_FINAL_022105 2/22/04
Table/Desk Installation
1 Attach the desk wedge.
If the desk wedge is not already attached, slide the tabs into the
holes as shown. Snap the wedge onto the base.
2 Connect the line cord(s) to the telephone and your modular
wall jack(s).
• If you have a single two-line wall jack, use only the black
(4-connector) line cord. Plug one end into the jack labeled
L1 OR L1/L2 on the back of the telephone. Plug the other
end into the wall jack. Make sure the cord snaps firmly into
place at both ends.
Two-line modular
wall jack
Black telephone
6
4:46 PM Page 6
line cord
• If you have two one-line wall jacks, use both long line cords.
For this installation option it does not matter which line cord
you use for each line. Insert one end of the first cord into the
jack labeled L1 OR L1/L2 on the back of the phone. Then,
plug the other end into the wall jack for Line 1. Insert one end
of the other cord into the jack on the back of the phone labeled
L2. Then, plug the other end into the wall jack for Line 2. Make
sure the cords snap firmly into place at both ends.
Modular
wall jack
for Line 1
Telephone
line cord
3 Connect the handset to the telephone.
Plug the coiled handset cord into the handset jack on the left side of
the phone. Plug the other end of the coiled cord into the handset,
then hang up.
Modular
wall jack
for Line 2
Telephone line cord
continued on page 8
7