Ipi Electronic System Wiring Diagram - Empire Comfort Systems DVL25FP32-1 Installation Instructions And Owner's Manual

IPI ELECTRONIC SYSTEM WIRING DIAGRAM

WHITE
CPI/IPI
SWITCH
REMOTE RECEIVER
(OPTIONAL)
+ ON
REMOTE
- OFF
AC/DC
POWER ADAPTOR
BATTERY HOLDER
If any of the original wire as supplied with this unit must be replaced, it must be replaced with equivalent gauge and temperature
rated wire.
This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently
located, manufactured (mobile) home where not prohibited by local codes. This appliance is not convertible for use with other gases,
unless a certified kit is used.
CAUTION: Do not operate the appliance with panel(s) removed, cracked or broken. Replacement of the panel(s) should be done by
a licensed or qualified service person.
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause property damage, personal injury or loss
of life. Installation and service must be performed by a qualified installer, service agency or the gas supplier.
29210-0-0911
BLUE BLUE
WHITE
ON/OFF
OR
SWITCH
WHITE
GREEN
BLACK
RED
BLACK
RED
GREEN
ORANGE
YELLOW
GAS CONTROL
VALVE
(GND)
PILOT
ORANGE
WHITE
ELECTRONIC
CONTROL MODULE
Page 37