Alternate On/Off Switch Installation - Empire Comfort Systems DVL25FP32-1 Installation Instructions And Owner's Manual

ALTERNATE ON/OFF SWITCH INSTALLATION

WIRING THE FIREPLACE
NOTICE: Electrical wiring must be installed by a licensed
electrician.
DISCONNECT REMOTE CONTROLS IF YOU ARE ABSENT
FOR EXTENDED TIME PERIODS. THIS WILL PREVENT AC-
CIDENTAL FIREPLACE OPERATION.
Installation of Alternate Surround Panel ON/OFF Switch
An ON/OFF switch and wire assembly are provided. They are in-
cluded in the instruction packet.
Do not cut wire or insulation on metal edges.
NOTICE: Refer to surround panel installation instructions for
additional information on attachment.
Contemporary Surrounds
1. Find the coiled low voltage wire assembly and ON/OFF switch
located in the instruction packet.
2. Attach the flag terminal ends to the "TH/TP" and "TH" termi-
nals on the front terminal block of the gas valve. See Figure
40.
3. Run the low voltage alternate switch wires over to the right
or left surround panel. Then secure the wires with wire clips
provided. See Figure 39.
Right Side Installation
ON/OFF
SWITCH
ASSEMBLY
Insert ON/OFF switch into side panel then attach wire assem-
bly from valve terminals.
4. Remove the switch knockout on the side surround panel, then
install the ON/OFF switch. See Figure 39.
5. Connect the low voltage wires from the gas valve to the
ON/OFF switch.
6. Attach the surround panel assembly to the fireplace. Hang
the surround panel assembly on the face of the fireplace and
center left to right. Swing the surround panel assembly in-
ward until the bottom magnets contact the fireplace body side
flanges. This secures the surround panel assembly to the
fireplace without screws.
Page 28
CAUTION
Left Side Installation
ON/OFF
WIRING FROM
SWITCH
MILLIVOLT GAS
ASSEMBLY
VALVE
Figure 39
Figure 40
29210-0-0911