Ipi Electronic System Wiring Diagram - Empire Comfort Systems MV CONTROL DVL36BP30KN-1 Installation Instructions Manual

IPI ELECTRONIC SYSTEM WIRING DIAGRAM

REMOTE RECEIVER
(OPTIONAL)
+ ON
REMOTE
- OFF
AC/DC
POWER ADAPTOR
BATTERY HOLDER
If any of the original wire as supplied with this unit must be replaced,
it must be replaced with equivalent gauge and temperature rated
wire.
This appliance is only for use with the type of gas indicated on the
rating plate and may be installed in an aftermarket, permanently
located, manufactured (mobile) home where not prohibited by
local codes. This appliance is not convertible for use with other
gases, unless a certified kit is used.
41971-4-1121
BLUE
WHITE
ON/OFF
OR
SWITCH
WHITE
GREEN
BLACK
RED
BLACK
RED
GREEN
ORANGE
YELLOW
GAS CONTROL
VALVE
(GND)
Improper installation, adjustment, alteration, service or
maintenance can cause property damage, personal injury
or loss of life. Installation and service must be performed
by a qualified installer, service agency or the gas supplier.
Electrical Grounding Instructions
This appliance is equipped with a three-prong (grounding)
plug for your protection against shock hazard and should
be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong from
this plug. The AC/DC adapter, if used, has a 2-prong plug
which does not require an additional ground.
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation.
PILOT
WHITE
ELECTRONIC
CONTROL MODULE
WARNING
WARNING
CAUTION
ORANGE
Page 63