Table of Contents
Advertisement
IPI ELECTRONIC SYSTEM WIRING DIAGRAM
WHITE
CPI/IPI
SWITCH
REMOTE RECEIVER
(OPTIONAL)
+ ON
REMOTE
- OFF
AC/DC
POWER ADAPTOR
BATTERY HOLDER
If any of the original wire as supplied with this unit must be
replaced, it must be replaced with equivalent gauge and
temperature rated wire.
This appliance is only for use with the type of gas indicated
on the rating plate and may be installed in an aftermarket,
permanently located, manufactured (mobile) home where not
prohibited by local codes. This appliance is not convertible for
use with other gases, unless a certified kit is used.
REMOTE RECEIVER
If a remote receiver is installed in the insert, a receiver shield
should be placed over the receiver. The receiver shield is
included in the instruction packet. The shield must be hand
formed as shown. See Figure 33.
Remote Receiver Shield
Page 38
BLUE
BLUE
WHITE
ON/OFF
OR
SWITCH
WHITE
GREEN
BLACK
RED
BLACK
RED
Remote Receiver (Optional)
Figure 33
GREEN
ORANGE
YELLOW
GAS CONTROL
VALVE
(GND)
Do not operate the appliance with panel(s) removed,
cracked or broken. Replacement of the panel(s) should be
done by a licensed or qualified service person.
Improper installation, adjustment, alteration, service or
maintenance can cause property damage, personal injury
or loss of life. Installation and service must be performed
by a qualified installer, service agency or the gas supplier.
Electrical Grounding Instructions
This appliance is equipped with a three-prong (grounding)
plug for your protection against shock hazard and should
be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong from
this plug. The AC/DC adapter, if used, has a 2-prong plug
which does not require an additional ground.
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation.
WHITE
ORANGE
ELECTRONIC
CONTROL MODULE
CAUTION
WARNING
WARNING
CAUTION
41380-0-0120
PILOT
Advertisement
Table of Contents
Troubleshooting
