Auxiliary Equipment; Heat Pump - Jandy Aqualink RS Owner's Manual

Auxiliary Equipment

The AUX modes control each of the auxiliary devices plus an extra AUX. To assign a different name to an auxiliary
device, use the SYSTEM SETUP and LABEL AUX menus.
To turn an Auxiliary on or off
Highlight an AUX and press SELECT. Use the SELECT button to turn the equipment on or off.

Heat Pump

NOTE
This equipment may not be part of your system. Please check with your installer.
The HEAT PUMP selection controls the heat pump operation. In order to use the heat pump, the filter pump must be
turned on and the heat pump must be in HEAT MODE (see page 23, Using the System Setup Menu), and the switch
on the heat pump on the equipment pad must also be set to HEAT MODE.
NOTE
HEAT PUMP takes the place of EXTRA AUX or SOLAR HEAT. It is not possible to have any two of these on the
EQUIPMENT ON/OFF menu at the same time.
To use Heat Pump
Highlight HEAT PUMP and press SELECT. Press the SELECT button to enable/disable the HEAT PUMP. The HEAT
PUMP uses the heater temperature set point.
FILTER PUMP ON
SPA OFF
POOL HEAT OFF
SPA HEAT OFF
SOLAR HEAT OFF
AUX 1 OFF
AUX 2 OFF
AUX 3 OFF
AUX 4 OFF
AUX 5 OFF
OFF
AUX 6
OFF
AUX 7
FILTER PUMP ON
SPA OFF
POOL HEAT OFF
SPA HEAT OFF
HEAT PUMP OFF
AUX 1 OFF
AUX 2 OFF
AUX 3 OFF
AUX 4 OFF
AUX 5 OFF
AUX 6 OFF
AUX 7 OFF
FILTER PUMP ON
SPA OFF
POOL HEAT OFF
SPA HEAT OFF
SOLAR HEAT OFF
AUX 1 ON
AUX 2 OFF
AUX 3 OFF
AUX 4 OFF
AUX 5 OFF
OFF
AUX 6
OFF
AUX 7
FILTER PUMP ON
SPA OFF
POOL HEAT OFF
SPA HEAT OFF
HEAT PUMP ENA
AUX 1 OFF
AUX 2 OFF
AUX 3 OFF
AUX 4 OFF
AUX 5 OFF
AUX 6 OFF
AUX 7 OFF
Page 11