Table of Contents
Advertisement
20
Installation (for qualified installers only)
Surround Panel Installation
NOTE: The insert may be installed without surround panels.
3-Piece Surround Panels
PANEL SIZE
8" x 10" Rectangular
Arched (8" x 10")
10" x 13" Rectangular
4" x 6" Rectangular
1
Follow the directions to the
right to install the side panels.
2
Follow the directions below to
install the top panel.
Top
Panel
a
Install the top panel so
the tabs insert into the
joggle clips on the top
panel
© Travis Industries
WIDTH
40-3/8"
40-3/8"
44-3/8"
37-1/8"
b
Line up each side surround
panel and insert two screws from
the inside to secure in place.
Top Trim
Spring
Clips
"L" Bracket
Right Side Trim
4120228
HEIGHT
PART #
28-7/8"
96100301
28-7/8"
98500605
31-7/8"
96100302
25"
96100300
Micro (1/16")
Standard
Screwdriver
b
Top Trim
"L" Bracket
Right Side
Trim
Trim Installation:
Insert one leg of each "L" bracket into the top
and side trim piece. Align the trim to form a
precise corner, then tighten the two set
screws with a small standard screwdriver.
Slide the trim over the panels. Place the
spring clips behind the panels at the locations
shown. This keeps the trim tight against the
panel.
Optional Knock-Out
An optional knock-out is provided if the power cord is
routed behind the surround panel.
Pre-thread the holes on the surround
a
panels with the screws included in the
surround panel kit.
5/16" Nutdriver
Run the power cord to
the right of the insert.
COVER PLUGS FOR
ON/OFF SWITCH AND
RHEOSTAT
Install the button plug
and switch plug into the
surround panel trim to
conceal the mounting
holes (see the illustration
100-01285_000
below).
Advertisement
Table of Contents
