D-Link DSR-250N User Manual page 182

Unified Services Router
Internet on port %d
Enabling remote access management
for IP address range"
Enabling remote access management to
only this PC.
Disabling Management Access from
Internet on port %d
Disabling remote access management
for IP address range"
Disabling remote access management
only to this PC.
MAC Filtering %sabled for BLOCK and
PERMIT REST.
MAC Filtering %sabled for PERMIT and
BLOCK REST.
Enabling Content Filtering.
Disabling Content Filtering.
Deleting rule, port triggering for protocol
TCP.
Deleting rule, port triggering for protocol
UDP.
Deleting rule, port triggering for protocol
TCP.
Deleting rule, port triggering for protocol
UDP.
Enabling rule, port triggering for protocol
TCP.
Enabling rule, port triggering for protocol
UDP.
Enabling rule, port triggering for protocol
TCP.
Enabling rule, port triggering for protocol
UDP.
Enabling DNS proxy.
Restarting DNS proxy.
checking DNS proxy for Secure zone.
checking DNS proxy for Public zone.
Enabling Block traffic from %s zone.
Configuring firewall session settings for "
Disabling DMZ
Disabling WAN-DMZ rules .
Enabling WAN DMZ rules .
Restarting DMZ rule having %s address
with %s address.
Enabling LAN DHCP relay.
OneToOneNat configured successfully
OneToOneNat configuration failed
Deleting scheduled IPv6 rules.
delete from FirewallRules6 where
ScheduleName = '%s'.
%d:%d:%d:%d:%d
Disabling Port Trigger Rule for
DEBUG %d:%d:%d:%d:%d
Adding Port Trigger Rule for
DEBUG %d:%d:%d:%d:%d
DEBUG Enabling Content Filter
DEBUG Disabling Content Filter
DEBUG Enabling Content Filter
Setting NAT mode for pLogicalIfName
DEBUG = %s
DEBUG Enabling DROP for INPUT
DEBUG Enabling DROP for FORWARD
DEBUG Enabling NAT based Firewall Rules
Setting transparent mode for
DEBUG pLogicalIfName \
DEBUG Enabling Accept for INPUT
DEBUG Enabling Accept for FORWARD
Setting Routing mode for
DEBUG pLogicalIfName \
DEBUG Enabling DROP for INPUT
DEBUG Enabling DROP for FORWARD
DEBUG Disabling NAT based Firewall Rules
Enabling Firewall Rules for URL
DEBUG Filtering & "
DEBUG Adding Firewall Rule for RIP Protocol
Restarting Schedule Based Firewall
DEBUG Rules
enabling IPS checks between %s and
DEBUG %s zones.
disabling IPS checks between %s and
DEBUG %s zones.
DEBUG Stopping IPS...%s
DEBUG IPS started.
DEBUG Route already exists
Route addition failed: Network
DEBUG Unreachable
DEBUG Route addition failed: Network is down
DEBUG Route addition failed
DEBUG Failed to add rule in iptables
DEBUG Failed to delete rule from iptables
fwLBSpillOverConfigure: Something
DEBUG going wrong here
fwLBSpillOverConfigure: unable to get
DEBUG interfaceName
fwLBSpillOverConfigure: Could not set
DEBUG PREROUTING rules
180
User Manual
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
DEBUG
ERROR
ERROR
ERROR