Testing The Lan Path From Your Pc To A Remote Device - D-Link DSR-250N User Manual

Unified Services Router
4.
Observe the display:

Pinging <IP address> with 32 bytes of data
Reply from <IP address>: bytes=32 time=NN ms TTL=xxx

Pinging <IP address> with 32 bytes of data
Request timed out
5.
If the path is not working, Test the physical connections between PC and router


6.
If the path is still not up, test the network configuration:


11.3.2 Testing the LAN path from your PC to a remote
device
From the PC's Windows toolbar, select Start > Run.
1.
2.
Type ping -n 10 <IP_address> where -n 10 specifies a maximum of 10 tries and <IP
address> is the IP address of a remote device such as your ISP's DNS server. Example:
ping -n 10 10.1.1.1.
3.
Click OK and then observe the display (see the previous procedure).
4.
If the path is not working, do the following:

If the path is working, you see this message sequence:
If the path is not working, you see this message sequence:
If the LAN port LED is off, go to the ―LED displays‖ section on page B-
1 and follow instructions for ―LAN or Internet port LEDs are not lit.‖
Verify that the corresponding link LEDs are lit for your network
interface card and for any hub ports that are connected to your
workstation and firewall.
Verify that the Ethernet card driver software and TCP/IP software are
installed and configured on the PC.
Verify that the IP address for the router and PC are correct and on the
same subnet.
Check that the PC has the IP address of your firewall listed as the
default gateway. (If the IP configuration of your PC is assigned by
DHCP, this information is not visible in your PC's Network C ontrol
Panel.)
150
User Manual