D-Link DSR-250N User Manual page 170

Unified Services Router
Created EAP/PEAP context: OK
Deleted EAP/PEAP context: OK
Upper EAP sent us: decision = %d
method state = %d
P2 decision=(%d); methodState=(%d)
Writing message to BIO: ERROR.
Encrypted (%d) bytes for P2
P2: sending fragment.
P2: message size = %d
P2: sending unfragmented message.
P1: Sending fragment.
P1: Total TLS message size = (%d)
P1: sending unfragmented message.
peapFragFirstProcess: TLS record size
to receive = (%d)
Setting version %d
PEAP pkt rcvd: data len=(%d) flags=(%d)
version=(%d)
Got PEAP/Start packet.
Got first fragment
Got fragment (n)
Got last fragment
Got unfragmented message
Got frag ack.
Ext AVP parsed: flags=(0x%x)
Mandatory bit not set: WARNING
Ext AVP parsed: type=(%d)
Ext AVP parsed: value=(%d)
Got PEAPv0 success!
Got PEAPv0 failure!
pCtx NULL.
Authenticator response check: Error
Authenticator response check: Failed
MS-CHAP2 Response AVP size = %u
Created EAP/MS-CHAP2 context: OK.
pCtx NULL.
Deleted EAP/MS-CHAPv2 context: OK
Not authenticated yet.
Authenticator response invalid
EAP-MS-CHAPv2 password changed.
Setting message in fragment buffer:
DEBUG ERROR
Allocating TLS read buffer is NULL:
DEBUG ERROR
DEBUG Setting last fragment: ERROR
DEBUG Getting message: ERROR
DEBUG Processing PEAP message: ERROR
DEBUG Setting fragment: ERROR
DEBUG Creating receive buffer: ERROR
DEBUG Setting first fragment: ERROR
DEBUG Sending P1 response: ERROR
NULL request (or response) PDU or
DEBUG NULL context: ERROR
Expecting start packet, got something
DEBUG else: ERROR
DEBUG Protocol version mismatch: ERROR
Processing PEAP message (from
DEBUG frag): ERROR
DEBUG Processing PEAP message: ERROR
DEBUG Processing PEAP message: ERROR
DEBUG Indicated length not valid: ERROR
Did not get Acknowledged result:
DEBUG ERROR
Cannot understand AVP value:
DEBUG ERROR
DEBUG eapExtResp is NULL: ERROR
eapWscCtxCreate:
DEBUG EAPAUTH_MALLOC failed.
eapWscProcess: umiIoctl req to WSC
DEBUG failed, status = %d
DEBUG eapWscCheck: Invalid frame
DEBUG eapWscBuildReq: Invalid state %d
eapWscProcessWscResp: Invalid data
DEBUG recd pData = %p, dataLen"
Data received for invalid context,
DEBUG dropping it
eapWscProcessWscResp: Build
DEBUG Request failed
eapWscProcessWscResp: Invalid
DEBUG state %d
eapWscProcessWscResp: Message
DEBUG processing failed 0x%X
eapWscProcessWscData: Invalid
DEBUG notification recd %d
DEBUG unable to initialize MD5
DEBUG MDString: adpDigestInit for md5 failed
DEBUG EAPAUTH_MALLOC failed.
DEBUG EAPAUTH_MALLOC failed.
DEBUG NULL context created: Error
DEBUG NULL context received: Error
DEBUG Authenticator ident invalid.
DEBUG Success request message invalid:
168
User Manual
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR
ERROR