Fujitsu Compact Wall Mounted Type Installation Manual page 14

Heating Room Temperature Correction
• Depending on the installed environment, the room tempera-
ture sensor may require a correction.
The settings may be changed as shown in the table below.
Setting Description
Standard
Lower control
Slightly warmer control
Warmer control
Auto Restart
• Enable or disable automatic system restart after a power
outage.
Setting Description
Yes
No
* Auto restart is an emergency function such as for power fail-
ure etc. Do not start and stop the indoor unit by this function
in normal operation. Be sure to operate by the control unit,
or external input device.
Indoor room temperature sensor switching function
(Only for Wired remote controller)
• The following settings are needed when using the Wired
remote controller temperature sensor.
Setting Description
No
Yes
* If setting value is "00" :
Room temperature is controlled by the indoor unit tempera-
ture sensor.
* If setting value is "01" :
Room temperature is controlled by either indoor unit tem-
perature sensor or remote controller unit sensor.
Remote controller signal code
• Change the indoor unit Signal Code, depending on the re-
mote controllers.
Setting Description
A
B
C
D
External input control
• "Operation/Stop" mode or "Forced stop" mode can be elected.
Setting Description
Operation/Stop mode
(Setting forbidden)
Forced stop mode
En-14
9332279030-04_IM.indb 14 9332279030-04_IM.indb 14
Setting record
• Record any changes to the settings in the following table.
Filter sign
( ... Factory setting)
Cooler room temperature correction
Function Setting
Number Value
Heater room temperature correction
00
Auto restart
01
Indoor room temperature sen-
31
sor switching function
02
Remote controller signal code
03
External input control
After completing the FUNCTION SETTING, be sure to turn off
the power and turn it on again.
( ... Factory setting)
Function Setting
Number Value
00
40
01
( ... Factory setting)
Function Setting
Number Value
00
42
01
( ... Factory setting)
Function Setting
Number Value
00
01
44
02
03
( ... Factory setting)
Function Setting
Number Value
00
46 01
02
Setting Description Setting Value
9/8/2010 9:56:58 AM 9/8/2010 9:56:58 AM