Configuring Protected Ports - HP Q.11. (2510-24) Access Security Manual

Configuring Protected Ports

There are situations where you want to provide internet access to users but
prevent them from accessing each other. To achieve this control, you can use
the protected-ports command. The command applies per-port, and filters the
outbound traffic from a port. This allows the configuration of two port groups
on a switch—protected ports and unprotected ports. The ports have these
characteristics:
■ Traffic from protected ports is not forwarded to other protected ports.
Protected ports can communicate with unprotected ports, but not
■
with each other.
Unprotected ports can communicate with all ports.
■
The protected-ports command applies to logical ports (trunks as well
■
as untrunked ports)
Syntax: [no] protected-ports <port-list>
Prevents the selected ports from communicating with each
other.
Default: All ports unprotected.
no protected-ports all
Clears the protection from all ports; all ports can now com-
municate with each other.
ProCurve(config)# protected-ports 4-5
Figure 9-15. Example of Protected Ports Command for Ports 4 and 5
To display information about which ports have been configured as protected
ports, enter this command:
ProCurve(config)# show protected-ports
Configuring and Monitoring Port Security

Configuring Protected Ports

9-27