Cli: Setting Passwords And Usernames - HP Q.11. (2510-24) Access Security Manual

Procurve 2510 series
Table of Contents

Advertisement

If you have physical access to the switch, press and hold the Clear button (on
the front of the switch) for a minimum of one second to clear all password
protection, then enter new passwords as described earlier in this chapter.
If you do not have physical access to the switch, you will need Manager-Level
access:
1.
Enter the console at the Manager level.
Go to the Set Passwords screen as described above.
2.
Select Delete Password Protection. You will then see the following prompt:
3.
Continue Deletion of password protection? No
4.
Press the Space bar to select Yes, then press [Enter].
Press [Enter] to clear the Password Protection message.
5.
To Recover from a Lost Manager Password: If you cannot start a con-
sole session at the Manager level because of a lost Manager password, you
can clear the password by getting physical access to the switch and pressing
and holding the Clear button for a minimum of one second. This action deletes
all passwords and usernames (Manager and Operator) used by both the
console and the web browser interface.

CLI: Setting Passwords and Usernames

Commands Used in This Section
password
See below.
Configuring Manager and Operator Passwords.
Syntax:
[ no ] password <manager | operator > [ user-name ASCII-STR ]
[ no ] password < all >
Figure 2-2. Example of Configuring Manager and Operator Passwords
Configuring Username and Password Security
Configuring Local Password Security
• Password entries appear
as asterisks.
• You must type the
password entry twice.
2-5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

U.11. (2510-48)Procurve 2510-24Procurve 2510-48

Table of Contents