In-Circuit-Programming Connector (X17); Debug Connector (X21) - Fujitsu SK-96620_350-64PMC(1) User Manual

5.7 In-Circuit-Programming Connector (X17)

There is a flash-programming socket on the starter-kit, which makes it possible to program
the flash MCU with a special programming adapter. Mode pin MD0 and reset signal are also
available at this connector.
Pin Number Pin Signal
1 P00_0
2 P00_1
3 DEBUG I/F
4
5
6
7
8
9
10

5.8 Debug Connector (X21)

The MB96600 super series facilitates on-chip debugging via a single-wire system
with the embedded emulator MB2100-01-E. The emulator is connected to the starter
kit via SMA jack.
© Fujitsu Semiconductor Europe GmbH
SK-96620_350-64PMC(1) User Guide
Chapter 5 Connectors
Figure 5-1: In-circuit programming connector
Description
Port pin P00_0
Port pin P00_1
MB966xx: DEBUG I/F, MB963xx: MD0
MOD MB966xx: MD, MB963xx: MD2
RSTX MCU reset signal
SIN UART2 receive data
SOT UART2 transmit data
SCK UART2 clock
VCC Board supply voltage
GND Ground
Table 5-1: In-circuit programming connector
Figure 5-2: Debug Connector
- 33 - UG-960028-12