Programming The Internal Flash Memory; Asynchronous Mode - Fujitsu F2MC-16FX Series User Manual

4 Programming the internal Flash memory

All Flash devices have an internal bootloader for asynchronous- as well as synchronous-
Flash-programming:
< asynchronous-serial Flash-programming via X3
< synchronous-serial Flash-programming via X17

4.1 Asynchronous Mode

In order to program the Flash-ROM asynchronously, the tool "Fujitsu Flash MCU
Programmer for FMC16FX" can be used. This tool is available free on the Fujitsu Micros
DVD or Web Site (http://mcu.emea.fujitsu.com/: select < Software < Utilities)
The following procedure must be followed to enable Flash Programming:
1. Power off the board
2. Connect the Evaluation Board UART"A" or UART"B" to your serial PC communication
port. A straight 1:1 cable connection has to be used.
3. Check the Jumper-settings according to the UART as described in chapter 3.5
4. Configure the mode:
5. Power on the board
FMEMCU-UG-960010-12
Downloaded from Elcodis.com electronic components distributor
SK-96320-80PMC User Guide
Chapter 4 Programming the internal Flash memory
MD0 MD1 MD2 nc
Dip-Switch S2
(Flash mode)
1
ON
OFF
2 3 4
- 22 - © Fujitsu Microelectronics Europe GmbH