Verifying And Setting Snmp Values - HP L10 User Manual

2. From the Main menu, enter 2 (Set Networking parameters) to display the Network
Setup menu:
Network Setup Menu:
1. Return to Main Menu
2. Select IP address [current = nnn.nnn.nnn.nnn]
3. Select Subnetworking Mask [current = nnn.nnn.nnn.nnn]
4. Select Default Gateway address [current = nnn.nnn.nnn.nnn]
5. Save Network Setup changes and reboot
6. Proxy Master Setup
Enter 2 to set the hub IP address. A command prompt appears.
3.
4. Type the IP address for the hub, then press <
5. Enter 3 to set the Subnetworking Mask. A command prompt appears.
6. Type the Subnetworking Mask for the hub, then press <
7. Enter 4 to set the Default Gateway address. A command prompt appears.
8. Type the Default Gateway address for the hub, then press <
Enter 5 to save your changes. The hub is rebooted with the new values. The Main menu
9.
appears.
Caution You must enter 5 to save changes. If you do not want to change the hub values,
do not enter 5. Instead, enter 1 to return to the Main menu.

Verifying and Setting SNMP Values

Use the following procedure to set the following SNMP values. If you have hubs in a
cascaded configuration, only perform this procedure for the parent hub. The parent hub
should be the hub that has the LAN (ethernet) connection. Refer to the values you entered
in Table 1 on page 42 as you set the above parameters.
•
get community name
Enabling Hub Management
58
>.
E
NTER
>.
E
NTER
>.
E
NTER