Table of Contents
Advertisement
3.
Press <
>. The screen displays status messages; for example:
E
NTER
FLASH programming will take about 40 seconds
FLASH pgm:[$001000:$101000)->[$800000:$900000) >
Caution
Do not interrupt the display or press any keys during this process.
After about 40 seconds, the display continues.
When FLASH programming is completed, the checksum appears; for example:
FLASH programming will take about 40 seconds
FLASH pgm:[$001000:$101000)->[$800000:$900000) > complete, no errors
New FLASH checksum = 0x12FC
The value displayed can be different from the example shown here. Then the Boot
menu appears again.
Reinstalling the Hub Controller Firmware
1.
From the Boot menu, enter 2 to update the hub controller firmware.
2.
From the terminal emulator application, select the transfer option to send a text file.
The screen displays status messages and progress indicators; for example:
Ready to download Hub-Controller code to RAM
Start ASCII file (S-record format) transfer now
<Refer to terminal emulator user manual for instructions>
Press control-C at any time to cancel
3.
Send the following file you previously downloaded from the Hewlett-Packard Software
Depot:
IFCH3718.FRM
Several rows of dots appear to indicate download progress; for example:
...................................................................
...................................................................
...................................................................
...................................
If Firmware Upgrade Appears to Fail
82
Advertisement
Table of Contents
Troubleshooting
