HP L10 User Manual page 53

After a few minutes, the transfer prompt appears; for example:
Done, memory range [$00001000:$00004FFF]
Ready to transfer Hub-Controller code from RAM to FLASH
Note, once started, this step must not be interrupted
Press Enter to start, control-C to cancel
The values displayed for memory range represent low-level diagnostics; the values
displayed in the status message can be different from the values shown here.
4. Press < >. Additional progress indicators and status messages appear; for
E
NTER
example:
--+
$..................................................................
*******************************************************************
************************
The hub is automatically rebooted and additional messages appear:
DRAM test
SEEPROM test
FLASH checksum
Press Enter key for Boot Menu, Agent boot in 7 seconds
To reboot, you must interrupt the display to go to the Boot menu.
5. Immediately press <
If the Main menu appears instead of the messages above, enter 1 to reboot the
Note
hub, then press <
If the Main menu appears, ignore the Hub Controller version number. It may be
blank or UNKNOWN. If the version number is blank or UNKNOWN, the upgrade
version number will appear in the Main menu after you update the Hub Device
Agent code and reset the hub.
(this will take about 10 seconds)
(this will take about
(this will take about
> to display the Boot menu.
E
NTER
> before the timeout period is finished.
E
NTER
> passed
1 second) > passed
2 seconds) > passed
Updating the Hub Firmware
51