Table of Contents
Advertisement
2.
Partially install a screw (5/8-inch number 12-24) into the top hole of a pair
of holes that are 0.5 inches apart in each rack/cabinet upright as shown
in the illustration below. Tighten each screw enough to support the weight
of the switch, approximately two turns. Ensure that the screws are at the
same level in each upright.
Insert a screw into
the top hole of a
close (0.5-inch)
3.
Place the switch in the rack and lower it so the notches in the bottom of
the bracket slide onto the screws. Tighten these screws-be careful not to
overtighten.
Installing the Switch 208/224
Installation Steps
1-9
Advertisement
Table of Contents
