Table of Contents
Advertisement
User's Guide
Taking a minute to make sure that your StudioJet™ autoprinter is setup properly will make operation smoother and more
enjoyable.
Location
Next, pick a well suited location to setup your duplicator. You should choose a level and stable work surface in an area
with good ventilation, moderate temperature and humidity, and access to a grounded power outlet.
i
Consider using an uninterruptible power supply with surge protection (UPS) to protect your duplicator.
A. Assembling Your StudioJet™
1. Mount the disc input spindles by screwing them into the base of the disc input hopper (see Figure 2.0).
2. Mount the disc output tray by sliding it into the lower right base of the printer stand (see Figure 2.1). You will feel
a slight click when the tray has been slid all the way into the printer base.
Figure 2.0 Mounting Disc Input Spindles
B. Connecting Power to Your StudioJet™
1. Connect the power cord to the AC power adapter brick.
2. Connect the small power connector to the back of the printer.
3. Connect the power cord to a grounded 110 power outlet. At this time the green LED on the front right of the print-
er will turn on indicating that the printer has power. You may also hear the printer fan running. This fan helps to keep
the printer cool and helps to clear the interior of the printer from ink spray.
©2007 Recordex USA, Inc. All rights reserved.
Version: 1.1
Figure 2.1 Mounting Disc Output Tray
TM
®
Recordex StudioJet
9
Advertisement
Table of Contents
