Table of Contents
Advertisement
User's Guide
Accessing Printer Driver Preferences
These utilities will help you to test and maintain your
printer.
Test Print: Prints an alignment image that is 116mm in
diameter to assist with changing printer alignment
settings.
Clean: At times, especially if the printer has not been
used for a while, the ink nozzles will need to be cleaned.
The clean utility will clean out the nozzles.
Demo Print: The demo print button will send a photo
print job to the printer. This is an easy way to verify
that the printer is working properly.
Ink Level: The ink level indicator will only work while the
printer is printing. These levels are not always 100%
accurate. We recommend running cartridges until they
no longer print properly before replacing them.
i
Note: That the Ink Level utility will
not work if you have your printer connected
to the network with a wireless print server.
Your StudioJet like any automated disc printer may
require minor alignment after shipping or being moved.
If you notice a consistent misalignment of the print image
you should alter center offset of the printer.
First go to the Utilities tab and print a Test Print which
will print a disc with an alignment pattern. If the outside
diameter circle is not centered then adjust the offset
accordingly:
Move Up: Enter a negative value in the Y offset and
click offset.
Move Down: Enter a positive value in the Y offset and
click offset.
Move Right: Enter a positive value in the X offset and
click offset.
Move Left: Enter a negative value in the X offset and
click offset.
i
Note: To save an offset value you
must click the Offset button. Clicking OK
will not save an offset change.
©2007 Recordex USA, Inc. All rights reserved.
Version: 1.1
Figure 4.7: Utilities
Figure 4.8: Alignment
TM
®
Recordex StudioJet
21
Advertisement
Table of Contents
