Table of Contents
Advertisement
User's Guide
Using Discus to Create A Label
3
Figure 3.2 Adjusting The Size & Offset of the print image
Clicking Setup will open the printer dialog box. From here you can click Properties to enter the printer driver settings menu.
This is where you can select the print quality. For non-photo printing you will normally find Normal or Fast Normal to be
sufficient quality and this will save you ink. However, for best results when printing photos we recommend using water-
proof glossy inkjet media and setting the print quality to Best.
To print multiple copies you simple enter the number of copies you want to print in the printer dialog box and click print.
Your StudioJet™ will automatically load, print and eject however many discs you request to be printed.
©2007 Recordex USA, Inc. All rights reserved.
Version: 1.1
(Figure 3.2).
1
2
Recordex StudioJet
Outside and Inside Diameter Settings
1 - Outside diameter
Reduce if you are getting ink past
the outside printable area of the
disc.
Increase if your image is not print-
ing all the way to the edge of the
printable area.
2 - Inside diameter
Reduce if your image is not print-
ing all the way to the inside diam-
eter of the printable area.
Increase if your image is printing
on the inside hub of the disc on the
non-printable surface.
Adjusting the center offset - moving
the image up, down or side to side
3 - Center Offset
Reset. Clicking the middle circle
will return all offset settings to
zero.
Adjust. Clicking the arrows will
move the image in that direction
by one tenth of a millimeter.
TM
®
16
Advertisement
Table of Contents
