Table of Contents
Advertisement
User's Guide
Your StudioJet™ printer is equipped with an advanced disc printer driver with built in image masking which enables you to
print a perfectly round image from virtually any Windows application. This means that you do not need to worry about
cropping or modifying a photo or image to make it round.
First a few reminders about media and ink:
•
Capacity: Your autoprinter can hold and print up to 50 discs before needing to be reloaded. You can send a print
job of more than 50 copies but you will need to reload the printer as it gets low on discs.
•
Disc Quality: You should use high quality ink-jet printable media. Recordex recommends water proof ink-jet me-
dia by Kodak Media Products for best results. This media is available wherever you purchased your printer.
•
Print Surface: Only use ink-jet printable media. Using non-inkjet printable media will create a mess of ink as the
ink will not be able to adhere to the disc surface.
•
Ink Cartridges: Only use HP replacement ink cartridges for your StudioJet. Attempting to refill the ink cartridge is
highly discouraged. You will experience poor quality and may damage your printer. Refilled cartridges do not have
the same internal pressure as a new cartridge and there is a much greater chance that they will leak into your printer.
Check with your Recordex Dealer or local retailer for quality original HP Ink Cartridges.
Using Discus to Create A Label
Refer to the Discus user manual for how to use Discus to create an attractive disc label. You can access the manual by open-
ing Discus and then clicking on the Help Menu and choosing User Manual. (Figure 3.1)
Figure 3.1: Opening User Manual
The inside and outside diameter of the printable area of an inkjet printable discs often varies slightly from brand to brand.
For this reason it is sometimes necessary to print a sample disc and then make minor adjustments to the print settings. If you
are using Discus you should use the print tab to change these settings. If you are using another program to create your disc
label then you should refer to pages 17-21 for instructions on changing the print settings using the printer driver.
See the next page for instructions on using Discus to change the size of the print area.
©2007 Recordex USA, Inc. All rights reserved.
Version: 1.1
TM
®
Recordex StudioJet
15
Advertisement
Table of Contents
