Table of Contents
Advertisement
User's Guide
Using Your Preferred Graphics Program to Create Disc Labels
Your StudioJet™ autoprinter is equipped with a special printer driver designed to automask an image for printing to discs.
You can modify the masking settings to enable printing to hub printable and non-hub printable inkjet discs. This section will
walk you through using your preferred graphics program to create a disc label.
Open your graphics program and select Page Setup from the File menu. First make sure that the StudioJet is the selected
printer.
In most cases you can select the paper type from a drop down box, if this is the case then 120mm disc should show up in
the drop down list. Selecting this will in most cases automatically enter the correct page size. If this does not work then you
can manually set the page size to the following settings:
Next you will want to make sure that the printer margins are set correctly. Use these settings:
Create the document as you would normally do so and when you are finished print the document using the StudioJet printer
driver. You may want to print a single disc first to make sure that the image is aligned properly. If you need to change
the inside or outside diameter or the center offset (I.e. Move image up, down, left or right) then refer to Chapter 4: Printer
Driver Settings.
i
page size from the printer driver. In these cases even when you select
120 mm disc as the paper type you will notice that the page size is still
8.5 x 11. If this is the case then you should still set the margins to .3 and
create your design in the upper left corner of the document. You can then
print to the StudioJet and your image should be properly aligned.
©2007 Recordex USA, Inc. All rights reserved.
Version: 1.1
Page Size: 5.33" Wide x 5.33" High
Margins: Set top, bottom, left and right margin to 0.3"
NOTE: Some applications will not properly retrieve the correct
TM
®
Recordex StudioJet
17
Advertisement
Table of Contents
