Technical Specifications - HP ProLiant DL180 G Quickspecs

QuickSpecs

Technical Specifications

System Unit Dimensions (H x W x D)
(with bezel)
Weight
(approximate)
Input
Requirements
(per power supply)
BTU Rating
Power Specifications
Power Supply Output
(per power supply)
System Inlet
Temperature
Relative Humidity
(non-condensing)
Altitude
DA - 12903 Worldwide QuickSpecs — Version 8 — 5.16.2008
3.44x 17.64 x 27.50 in (8.75 x 44.80 x 69.88cm)
Maximum
(all hard drives, power
supplies and processors
installed)
Minimum
(one hard drive, power
supply and processor
installed)
Rated Line Voltage
Rated Input Current
Rated Input Frequency 50 to 60 Hz
Rated Input Power
Maximum
To review typical system power ratings use the Power Calculator which
is available via the online tool located at URL:
http://h30099.www3.hp.com/configurator/calc/
Power%20Calculator%20Catalog.xls
Click on the system of interest. Example: DL180 G5
Follow the instructions of the next screens.
Rated Steady-State
Power
Maximum Peak Power 750 W (at 100 VAC),
Operating
Non-operating
Operating
Non-operating
Operating
HP ProLiant DL180 G5
51.5 lb (19.22 kg)
35.0 lb (13.06 kg)
100 - 240 VAC
9.10 A (at 100 VAC),
4.5 A (at 200 VAC)
910 W (at 100 VAC),
900 W (at 200 VAC)
3107.82 BTU/hr (at 100 VAC),
3073.67 BTU/hr (at 200 VAC)
750 W (at 100 VAC),
750 W (at 200 VAC)
750W (at 200 VAC)
50° to 95°F (10° to 35°C) at sea level with an
altitude derating of 1.8°F per every 1000 ft
(1.0°C per every 305 m) above sea level to a
maximum of 10,000 ft (3050 m), no direct
sustained sunlight. Maximum rate of change
is 18°F/hr (10°C/hr). The upper limit may be
limited by the type and number of options
installed.
System performance may be reduced if
operating with a fan fault or above 86°F
(30°C).
-22° to 140° F (-30° to 60° C). Maximum rate
of change is 36° F/hr (20° C/hr).
10 to 90% relative humidity (Rh), 82.4° F (28°
C) maximum wet bulb temperature, non-
condensing.
5 to 95% relative humidity (Rh), 101.7° F
(38.7° C) maximum wet bulb temperature,
non-condensing.
10,000 ft (3050 m). This value may be limited
by the type and number of options installed.
Maximum allowable altitude change rate is
1500 ft/min (457 m/min).
Page 28