Gree GWH18AC-D3DNA1B Service Manual page 62

4. axial flow blade
Remove
Loosen the tight nut with spanner and remove the
nuts,
spring washer, plain washer, then remove the axial
flow blade forcibly.
5. Remove motor and motor support
Twist off the clamping screws, take out the motor,
twist off the screws used for fixing the motor support
,pull it upward and then remove the motor support.
6. electronic expansion valve and
Remove
four-way valve
Unsolder the spot weld between electronic expan-
sion
valve and other connection, and then remove the
electronic expansion valve.
Unsolder the spot weld between the four-way valve
and other connection, and then remove the four-way
valve.
clamp nut
axial flow blade
motor
support
tapping
screw
four-way
valve
electronic
expansion
valve
59
Removal Procedure
motor