Changing A Console Connection; Accessing System Logs; The Set_Complex Command - HP 9000 V2500 SCA Operator's Manual

SSP operation
Using the console

Changing a console connection

Once the console is started as a watch or a control connection, the
connection type can be changed with escape characters.
To change a watch window to an active console window, enter:
Ecf
CTRL-
To change an active console window to watch window, enter:
Ecs
CTRL-

Accessing system logs

Monitor system status via two logs, event_log and consolelogX
(where X is the node_id), located in /spp/data/complex_name on the SSP.
The event_log file periodically logs system status. Once the file reaches
1 Mbyte, the system compresses it to event_log.old.Z and creates a
new event_log file.
The consolelogX files grow without bounds. These need to be
periodically checked by the system administrator.

The set_complex command

From an existing shell on the SSP, the user can set the "default complex"
for the shell by executing the set_complex command.
set_complex complex name
The set_complex command lists the configured complex names and
prompts the user for a selection. After a complex has been selected, the
user can issue diagnostic, scan, and console commands against a
particular node ID (e.g. 0). The SSP software accesses the correct node by
combining the user-specified node ID with the complex name selected by
the last set_complex command run from the shell. The default complex
name is always visible. It is enclosed in parenthesis as part of the shell
prompt and included in the Window title if the shell is on the SSP
desktop.
set_complex default
If there is only one complex configured on a SSP, there is no need to run
the set_complex command since there is only one complex (in fact,
set_complex automatically assigns the default complex name without
52 Chapter 3