Test Mode; Mode 16; Equipment Required; The Clock - Colorado time systems Pro Pace Clock User Manual

Test Mode

Equipment required:

Set up:

Operation:
The clock records the next touchpad hits. The last one recorded
(push off) is compared with the initial touchpad touch and the differ-
ence between the two is displayed.
With a touchpad at one end, this is the time it took the swimmer to
make an initial turn, swim down the lane, turn at the other end, swim
back and complete the turn at the end with the touchpad.
With a touchpad at each end, this is the time it took the swimmer to
make an initial turn, swim down the lane and complete the turn at the
other end.
The clock displays the mid-race time until the clock is reset with a
double click from the Reset/Breakout input, or a start input.

Mode 16

Depends upon testing.
Follow specific instructions from CTS customer service representa-
tive.
The clock displays 16, indicating mode 16. It will then cycle through
a digit test. Note that the decimal after the third digit is never used,
and will not light during the digit test.
Input ports can also be tested. When an input port receives a signal
the clock shows which input port was triggered, as shown:
Touchpad PAd
RJP rJP
Start StArt
Reset/Breakout rESET
Training Modes
17