Introduction; How To Set Intensity And Mode; Intensity - Colorado time systems Pro Pace Clock User Manual

Introduction

Pace Clock Operation
Water Polo
Training Modes
Displaying Other Information
How to Set Intensity
and Mode

Intensity

Thank you for purchasing a Colorado Time Systems Pro Pace
Clock/Shot Clock.
This introductory chapter describes physical features of your Pro
Pace Clock/Shot Clock. Subsequent chapters describe how to set up
and use your Pro Pace Clock/Shot Clock in a variety of ways.
Chapter 2, beginning on page 5, describes how to physically set up
single or multiple Pro Pace Clocks for basic pace clock operation.
Chapter 3, beginning on page 7, describes using the units for Water
Polo as shot clocks and also for displaying game time and other
scoreboard data.
Chapter 4, beginning on page 9, describes the training modes, in-
cluding what the mode does and which other devices are needed for
the mode.
Chapter 5, beginning on page 19, describes using a Pro Pace
Clock/Shot Clock to display additional information. The information
available for display varies by sport.
Use the Mode switch on the front panel to set intensity and mode, as
follows:
When a Pro Pace Clock is turned on, the clock will first display
and a number for Intensity. While
adjusts the intensity of the display. Fifteen levels of intensity are
available, from 1 (lowest) to 15/16 (highest). Select the desired in-
tensity.
NOTE: The initial intensity displayed will be the last setting saved
before the clock was turned off. It will not change until the knob is
turned for the first time.
Introduction
is displayed, the Mode switch
in
Introduction
1
in
1