Pace Clock With Lap Splits; Relay Exchanges - Colorado time systems Pro Pace Clock User Manual

Pace clock with Lap
Splits
Equipment required:
Set up:
Operation:

Relay Exchanges

Equipment required:
Set up:
Operation:
ute, the time of the touchpad hit is shown alternating between sec-
onds and hundredths (SS.HH) and minutes and seconds (MM:SS).
A start input or a double click from the reset input will reset and start
the clock any time the running time is displayed.
Mode 4
Touchpad required; start system or pushbutton can be used to reset
the clock.
Connect the touchpad to either Touchpad input. If using a start sys-
tem or pushbutton for resetting the clock, connect the start system or
a pushbutton to the Start System input, or connect a pushbutton to
the Reset/Breakout input.
The clock displays 04, indicating mode 4. The display will flash, dis-
play :00, and begin counting up, showing the time as minutes and
seconds.
At each valid touchpad hit, the display shows the time of the
touchpad hit (lap split) in seconds and hundredths (SS.HH). The
running time is reset to 0 at the touchpad hit, and continues running
internally. Following the lap split display, the clock will resume dis-
playing the running time as minutes and seconds.
A start input or a double click from the reset input will reset and start
the clock any time the running time is displayed.
Mode 5
Touchpad and relay judging platform (RJP).
Connect the touchpad to either Touchpad input. Connect the RJP to
the Relay Platform input.
The clock displays 05, indicating mode 5. The numbers on the dis-
play go blank, leaving the colon and rightmost decimal lit. The clock
is waiting to record a relay exchange.
RJP input times are recorded, and the first touchpad hit is recorded.
For a legal relay exchange (the touchpad hit occurred before the re-
lay takeoff), the display shows the relay exchange time in seconds
and hundredths (SS.HH). For an illegal relay exchange (the
Training Modes
11